The digital current sensor continuously monitors the motor current. It can be set for both the opening or closing cycles. If the gate is closing and hits a vehicle, the sensor detects the increased load on the motor and reverses. If the gate is opening and hits a vehicle, it stops. The sensor is smart enough to not react to wind resistance or operation on off-level installations.

Chassis
Constructed with 1/4", sanded, welded, and gold zinc plated sheet metal.

Output shaft
1" cold-rolled steel.

Worm gear reduction
30-to-1 worm gear reduction in oil bath.

Motor
Two 1/2 hp, instant reversing, 120VAC, 8 amp that work together simultaneously.

Cover
High density polyethylene plastic for long life protection.

Finishing
All metal parts are gold/zinc-plated for rust-proof protection.

Cycles
35 hour with 36 foot gate.

Modular board
Uses LEDs to indicate all input and output functions of the gate operator.

ERD
The two-way reversing sensor can be set for close or open cycles. If the gate hits a vehicle while closing, it reverses. If it hits a vehicle while opening, it stops.

Digital motor protection
Shuts off the motor after it reaches the stall amp for 3 seconds, then resets itself within 15 seconds.

Timer
Can be set from 0 to 60 seconds or for a "switch open/switch close" type operation.

Master/slave
Dictates synchronized movement between two gate operators.

3 spike suppressors
Fast response time (50 nanoseconds) when subject to an impulse surge (lightning strike) up to 100 amps.

Overload alarm sensor
Alarm is activated (beep sound) whenever the motion of the gate is held by an unwanted object.

Alternate outputs
Master/slave, alarm system, center loop, pilot door, and one 3-push-button station.

Electronic inputs
Radio receiver, key switch, safety loop, drop-out loop, exit loop, telephone entry system, computer input, fire department key switch and 3-push-button station.

Gate traveling time
Adjusted by a precision mechanical device and electrical limit switch.

NOTE: Gate travel speed may be impeded by installation, temperature, voltage differences and frequencies.

7 YEAR WARRANTY-SINGLE HOME USE
5 YEAR WARRANTY-COMMERCIAL USE

Elite Access Systems, Inc. warrants all commercial Gate Operators to be free of defects in workmanship and material for a period of 7 years for single home use and 5 years for commercial use, from the date of purchase. Wear and tear on all SL3000 Series gate operators is covered under this policy. Vandalism is not covered under this policy. Caution, in order to obtain full warranty, send the registration card by certified mail within 30 days from purchasing date to Elite Access Systems, Inc., otherwise a one year warranty will apply. Materials, components and specifications are subject to change without notice.